GOAL ZERO TANK PRO 4000 Manual De Instrucciones página 6

5. Ensure that the feet on the Yeti PRO 4000 are aligned with the feet pockets
in the lid of the Tank PRO 4000.
6. Once aligned, lift and align the latch on the opposite side of the Tank PRO
4000 with the slot in the bottom of the Yeti PRO 4000 and lock into place.
7. Plug the Tank PRO cable into the QS10 port on the Yeti PRO 4000. If
using extension cables, plug the Tank PRO cable into the female end of the
extension cable, then plug the extension cable into the Yeti PRO or Tank PRO
4000.
Male QS10
Chaining Cable
BACK
6
Subsequent Tank PRO 4000 Setup
1. Turn off the power on all devices.
2. Unplug the Yeti from existing Tanks.
3. Unlatch the brackets that connect your Yeti PRO 4000 to the Tank.
4. Carefully lift the Yeti off of the Tank and set it aside. Two person lift required.
5. Lift your new Tank and align it with the feet pockets on the Tank you are
stacking it on. (Be sure it is facing the same direction as the Tank below it)
6. Follow steps 2-7 in the section above.
Pairing the Tank PRO 4000 with the Yeti PRO 4000
1. Ensure Tank PRO 4000 power switch is OFF.
2. Plug the Tank into the Yeti (See page previous section for instructions on how
to plug in QS10).
3. Switch the Tank power switch to ON.
4. Observe the Tank icon on the Yeti display.
5. Observe the Status light blinking on the Tank PRO. This indicates the Tank is
equalizing with the Yeti.
NOTE: It may take up to 12 hours for Tanks to equalize with the Yeti
depending on how many units you have connected.
6. If adding additional Tank PRO 4000 units to your power stack, ensure the
power button is turned off. Then plug the additional Tank into the previously
connected Tank. Once connected, you can turn the power on.
Expansion Port
(QS10) Battery
Connector
FRONT
a. The Tank icon on the Yeti will appear when the Yeti detects a Tank.
a. If blinking, the Status light indicates the batteries are equalizing.
b. When the Status light stops blinking and remains on, this indicates
that the Tank and Yeti power stack is ready for use and will function as
one unit.
7