Descargar Imprimir esta página

Jata JVVP3060 Instrucciones De Uso página 8

Ventilador de pie

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
• VERY IMPORTANT: Do not immerse the fan in water or any
other liquid.
• This appliance has been designed for domestic only. Don't
allow children play with the appliance. Keep the fan out of the
reach of children.
• Make sure neither the appliance nor the cable are in direct
contact with hot surfaces or objects.
• Always place it on a flat and stable surface.
• Do not use outdoors.
• Do not use it without the frontal grid correctly assembled.
• Do not put the fingers or other objects into the fan to prevent
the engine block.
• Manipulation or replacement of any component must be
performed by an authorized service centre.
• If the power cord is damaged, it must be replaced by the
manufacturer or by its after-sales service or similar qualified
personnel to avoid a danger.
ASSEMBLING INSTRUCTIONS
• Remove the "L" screw from the tube (10) and insert it into the base, after that you can tight the "L" screw.
• Assemble the tubes (10) securing them with the wing nuts (11).
• Insert the head (6) to the tube and fix it.
• Unscrew the nut to fix the propeller (8) clockwise and the grid nut (7) anticlockwise.
• Place the rear grid (4) into the motor shaft and fix it with the screw grid by turning it clockwise.
• Place the blade (1) into the shaft by pressing till the end and screw the guard cap (8) into the shaft
anticlockwise.
• Position the front grill (5) matching the notches on the rear grill (4) with the slots on the front grill (5), rotate
it slightly to close it and secure it with the side security screw.
INSTRUCTIONS OF USE
• Remember the fan always must be placed on a flat and stable surface.
• Plug the appliance into the mains.
• Move the air flow by turning the head or moving up and down the head till getting the desired position.
• Push the oscillation knob to active the oscillation function (9).
• Raise the oscillation knob to stop this function.
• Press the speed selector (2) to:
-Position 0 - Off.
-Position 1 - Minimum speed.
-Position 2 - Medium speed.
-Position 3 - Maximum Speedy.
8

Publicidad

loading