Kicker PXIBT100.2 Manual Del Propietário página 4

Wiring: Disconnect the vehicle's battery to avoid an electrical short. Connect the PXIBT harness to the
amplifi er. A good ground connection is important. If this PXIBT100.2 is mounted in the front fairing of a
motorcycle, it will be best to extend the ground wire all the way to the battery.
Install a 15A fuse at the yellow +12V constant wire. Fuse installation should be within 18" (45cm) of the
battery and in-line with the harness' power cable, which is connected to your PXIBT100.2 unit. If you ever
need to remove the amplifi er from the vehicle after it has been installed, the ground wire should be the last
wire disconnected from the amplifi er--just the opposite as when you installed it.
+12V Constant
+12V Ignition
Remote turn-on out
Ground
OPERATION
USB Input and Charging
4
2016 PXiBT100.2 Rev G.indd 4 2016 PXiBT100.2 Rev G.indd 4
PXIBT100.2 unit
3.5mm aux RCA Out
input
Remote control input
L +
L -
R+
R-
Crossover Switches
To 2Ω or 4Ω
speakers
12/8/2015 11:35:28 AM 12/8/2015 11:35:28 AM