Publicidad
Idiomas disponibles
Idiomas disponibles
GENERAL ASSEMBLY INSTRUCTIONS
A Phillips head screwdriver is required.
2
1
6c
6b
10
11
WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VACUUM.
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the powerhead off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank. Make sure you have all contents as listed
on page 7 (Fig. 4).
5. Turn the collection tank on its side and insert the four caster feet into the slots on the collection
tank and tighten with supplied screws. Verify that the caster feet are mounted correctly. Do not
over-tighten screws (Fig. 5).
6. Position the hose storage rack as illustrated. Fully insert one end of the hose storage rack into
the slot illustrated by the arrow, then pull the other end of the hose storage rack to align with
the corresponding arrow and insert into the slot until it is secured in place (Fig. 6a - 6d).
7. Your vacuum comes ready for dry vacuum cleaning. If the cartridge filter is not installed, refer
to page 14 for installation instructions (Fig. 7 & 8).
8. For wet vacuum cleaning, remove the cartridge filter, and install the supplied foam wet filter.
See page 14 for the foam wet filter installation instructions (Fig. 9).
9. Place the powerhead back on the collection tank and secure into place using the latches
(Fig. 10 & 11).
10. Insert the locking end of the hose into the vacuum port on the collection tank and turn
clockwise to lock into place (Fig. 12).
11. Choose the desired accessory and insert onto the free end of the hose or extension wand
(Fig. 13).
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than the
other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet.
Do not change the plug in any way. Double insulation
grounded power cord and grounded power supply system.
3
6d
12
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
4
5
7
8
13
eliminates the need for the three-wire
8
6a
9
Publicidad
