Weber SUMMIT S-670 Guia Del Propietario página 20

A short power cord is supplied to reduce the risk of
tripping over the cord. Extension cords may be used, but
caution must be taken to prevent tripping over the cord.
In absence of local codes the rotisserie motor must be
grounded electrically in accordance with the National
Electric Code, ANSI / NFPA 70, or Canadian Electrical
Code, CSA C22.1.
CAUTION: Do not route rotisserie motor power cord through
the retractable rotisserie opening in the side table.
CAUTION: inspect power cord before each use. if cord
is damaged, do not use. Contact the Customer Service
Representative in your area using the contact information on
our web site. Log onto www.weber.com ®.
3) Slide one of the s 3it forks towards the right side of the rotisserie shaft, making sure
that the spikes face to the left and the fork screw faces down.
WARNING: Setup up the rotisserie with food before lighting
rotisserie burner.
OPERATING
1) To set up rotisserie motor, push the button on the retractable rotisserie panel(a).
Pull rotisserie panel towards you until it snaps into place(b).
2) Remove power cord and plug into power source.
4) Push the rotisserie shaft through the center of the food. Insert the tines of both spit
forks into the food. The food should be centered on the shaft. Tighten the spit fork
screw(c).
(c)
Slide another spit fork onto the rotisserie shaft, making sure that the spikes face
to the right and the fork screw faces up. Insert the tines of both spit forks into the
food. Tighten the spit fork screw(d).