Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION:
not too much fuel in the fuel tank. The
fuel expands when it becomes hot.
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before you start the
engine.
Note:
To see where the fuel tank is on your product,
Introduction on page 2 .
refer to
To start the product
1. Move the throttle control to the idle position.
2. If the engine is cold push the choke control (A) to the
closed choke position.
3. Push the air purge bulb (B) again and again until fuel
starts to fill the air purge bulb. It is not necessary to
fill the air purge bulb fully.
4. Put the product on a flat surface on the ground.
8
Make sure that there is
A
B
5. Hold the product with the right hand.
CAUTION:
hold the product.
6. Pull the starter rope handle slowly until resistance
occurs.
7. Pull the starter rope handle quickly with the left hand.
Pull the starter rope handle again and again until the
engine starts.
Note:
Do not pull the starter rope handle to full
extension and do not let go of the starter rope
handle.
8. If the engine is cold set the choke control to the open
position.
9. If the engine is cold let the engine operate for 2-3
minutes to become warm before operation.
WARNING:
the engine is started and when the
product is set at idle speed. Do not let
persons to come near the product or the
blower pipe.
To operate the product
•
Operate the product at usual work hours. Obey local
regulations.
•
Decrease the pieces of equipment and select the
correct speed for your task. Use the throttle at lowest
position possible to prevent more noise and dust
than necessary.
•
Keep the blower nozzle near the ground.
Note:
RedMax recommends that you use the full
blower nozzle extension.
•
Make a note of the wind direction and operate the
product in the direction of the wind.
•
Use applicable garden tools to release material from
the ground.
•
In areas with dust, use spray equipment to wet the
area. This decreases the operation time.
Do not use your feet to
Air is released when
2416 - 001 - 08.03.2024
Publicidad
