Publicidad
Idiomas disponibles
Idiomas disponibles
STARTING COMPRESSOR
Pre-starting Checklist:
Always check and correct before starting:
• Check unit for missing parts or damage.
• Check for loose nuts and bolts.
• Check drain cocks and close if open.
• Check compressor oil level.
1. Move On/Off lever (A) to the
"OFF" position.
2. Plug the power cord into the
power receptacle.
3. Move On/Off lever (A) to the
"ON" position.
4. Leave compressor in "ON"
position while in use.
5. Adjust outlet air pressure to desired
setting by turning pressure regulator
knob "B." Turn knob clockwise (+) to
increase air pressure,
counterclockwise (-) to decrease air
pressure. Outlet air pressure is
indicated by gauge (C). Tank pressure
is indicated by gauge (D).
6. Connect air hoses to quick-connect fittings (E) using a male quick-connect fitting.
To connect air hose, push back outer ring on compressor fitting, insert male hose
connector, and release ring. To release air hose, push hose fitting in, push back
outer ring on compressor fitting, and pull male hose connector out.
7. To stop compressor, move On/Off lever (A) to the "OFF" position. DO NOT stop
compressor by unplugging power cord.
WARNING: High pressure air will escape when hose is disconnected. Keep face away
from fittings to prevent dirt and debris from being blown into eyes. Always wear
glasses with side shields to protect eyes when using compressor.
15
OPERATION
Publicidad
