Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
COMPRESSOR MAINTENANCE SCHEDULE
Daily
1. Check compressor pump oil level, and fill as needed.
2. Drain moisture from tanks daily. Open drain slowly and let air
pressure bleed down gradually before opening drain valve completely.
3. Perform a visual inspection of compressor. Make sure belt guard is in
place, and all components are in good condition.
4. Check for unusual noise or vibration during operation, and have
problem corrected. Contact your Grip-Rite dealer for service.
Weekly
1. Check intake air filters and clean with soapy water if necessary.
Rinse and allow to dry before use. Replace filter if worn or damaged.
2. Check Pressure Relief Valve for proper operation. With tank pressurized,
pull on Pressure Relief Valve ring. Air must exhaust when ring is pulled.
Release ring - air must stop exhausting when ring is released.
3. Check V-belt for damage or wear, and replace if necessary.
4. Clean dust and debris from cylinder heads, fan blades, intercooler, and air tanks.
5. Check for leaks, cracks, or corrosion on tank, fittings, and tubing. Discontinue
use of equipment if leaks or other major problems are found, and repair unit
before placing back into service.
3 Months/300 Hours
1. Change compressor oil and air filter.
2. Clean/blow off compressor pump fins and motor.
3. Check for air leaks at connections, and tighten fittings if necessary.
4. Check tank for cracks, corrosion, leaks, or other damage. Never use a
compressor with a damaged tank.
5. Check warning labels for legibility, and replace if necessary. Contact your
Grip-Rite dealer for replacement labels.
16
Publicidad
