GPI EZ-8 Manual Del Propietario Del Producto página 11

MAINTENANCE
NOTE: This pump is designed for minimum maintenance. The motor bearings
are self-lubricating. Inspect the pump and components regularly for fuel leaks
and make sure the hose and power cord are in good condition. If damaged,
replace before use. Keep the pump exterior clean to help identify leaks.
IMPORTANT: Do not use this pump for water, chemicals or herbicides.
Dispensing any fluid other than those listed in the owner's manual may damage
the pump (see BEFORE YOU BEGIN: Fueling Compatibility Statement at front
of the owner's manual). Use of the pump with unauthorized fluids will void the
warranty.
Clean Strainer
1. Turn the pump off and disconnect from power. Remove the pump assembly
from tank. Remove the gear coverplate and inspect strainer for damage
or clogs (see Figure 12). Clean the strainer with a soft-bristled brush and
solvent. If the strainer is very dirty, compressed air may be used.
NOTE: The tank mount fitting for this pump is not removable.
Figure 12
Scan the QR code below for more maintenance,
troubleshooting, and repair resources.
EN
Strainer
Tank Mount
1
2
11