GPI EZ-8 Manual Del Propietario Del Producto página 8

INSTALLATION INSTRUCTIONS ( CONTINUED )
NOTE: If your tank is 15 - 24 inches deep, do not use the included suction pipe
extension; if your tank is 24 - 40 inches deep, attach the suction pipe extension
(see Figure 4).
24" - 40" Extension Pipe
Figure 4
Install Pump on Tank
1. Clean the tank interior of all dirt and foreign material.
2. Carefully lift pump / suction pipe assembly and insert suction pipe into the
tank opening.
Position the pump mount and tighten securely, making sure the threads
are not cross-threaded (see Figure 5).
NOTE: To prevent pressure buildup and possible fuel leaks, make sure the fuel
tank is properly vented. A vent cap rated at
3 psi (20.68 kPa) or less is recommended.
Install 90 Degree Street Elbow, Hose and Nozzle
1. Seal the threaded end of the 90° street elbow and both ends of the
discharge hose with 3 to 4 turns of supplied thread tape or a thread-sealing
compound approved for use with petroleum fuels.
2. Using pliers, remove the plastic plug from outlet port on top of pump. Thread
the 90° street elbow into outlet port and tighten securely
(see Figure 6).
3. Thread one end of hose into the 90° street elbow and tighten securely (see
Figure 7). Thread opposite end of hose into nozzle and tighten securely.
4. Place the nozzle into the nozzle holder on the end of the pump motor
housing (see Figure 8). Note that the nozzle cannot be placed in the holder
unless the pump switch is OFF.
Figure 5
Figure 7
8
EN
Figure 6
Figure 8
15" - 24" Telescoping Suction Pipe