Publicidad
Idiomas disponibles
Idiomas disponibles
Kettle [BOIL]
• Add water or other liquid that you want to heat to the maximum level.
• When starting the working mode, the machine will heat up until the water boils.
• In 6 minutes the program will end.
Cleaning [WASH]
• This program is fixed, add water up to the maximum level.
• The working mode lasts about 1 minute.
Keep warm [WARM]
• With this function you can keep your drinks warm for up to 6 hours.
INTELLIGENT ALTITUDE IDENTIFICATION SYSTEM
Before using the product for the first time, follow these steps:
1. Add water to the cup up to the upper limit of 800 ml, making sure it is below the water
level. No need to add any ingredients.
2. Connect the product to the main power source. After turning on the machine, hold down
the [TIMER] button for about 3 seconds. The boiling water function indicator will light up
and the digital display will show the water temperature in real time.
3. During the heating process, the water will boil strongly. Do not turn off or unplug the prod-
uct. After the smart identification is finished, the digital display will flash and the function
lights will turn off. Then press "Function/Cancel" to select the desired function.
4. After completing the intelligent recognition process, the "Keep Warm" function on the op-
eration panel will be ready to use.
1. When the product is connected to the light and in pause mode, all the indicators will be on.
2. Repeatedly press the [FUNCTION] button to select the function you want. Each time it is
pressed, the functions progress sequentially.
3. The light of the function you have selected will flash for a few seconds. When there is no
operation, the machine goes into operation after 5 sec.
4. If you want to program the machine, once the function is selected, press the [TIMER] but-
ton to indicate the waiting time you want.
5. The digital display will show "06". Each time you press the [TIMER] button again will ad-
vance one hour.
6. After selecting the schedule time, when there is no operation selected, the machine en-
ters work standby mode after 5 seconds (beeps three times at the same time).
7. After power on, if you open the cover, the machine enters the protection state, stopping
working. It shows the error "E1" and its remaining indicator lights go out. Closing the lid
again returns the machine to standby mode.
8. After entering the working mode or the function you need, press [FUNCTION/CANCEL]
button for 1.5 sec, the machine will stop working and return to standby mode.
9. After the work mode is finished, the machine returns to standby mode. The indicator lights
keep on and the beep sounds 10 times.
HOW TO USE
E NGLI SH
9
Publicidad
