Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
1. Never operate this unit if the specification is out of the rating.
2. This unit may become warm during use. This is normal.
An adapter (CA78M), used on 100-240V~ 50/60Hz, is included.
Before using the Class 2 Power Supply, read these instructions carefully.
Input: 100-240V~ 50/60Hz 0.2A
Output: 4.5V DC 1200mA
FEATURES
• NEW Gold Titanium Wedge Blade
• New 5-Detent Taper Control
• New Long-Life ball bearing DC Motor – 6500 RPM
• Ergonomic-Grip Housing
• NEW Lithium-Ion Battery w/ 2 Hours Runtime
• NEW LED Low Battery Indicator
• Cord/Cordless
• 8 Comb Attachments
• Cleaning Oil
• Cleaning Brush
• Professional Cord
FX673N IB-17456.indd 5-6
FX673N IB-17456.indd 5-6
OPERATING INSTRUCTIONS
Charging the Appliance
IMPORTANT! Only use the adaptor (CA78M) supplied with this appliance. This
clipper is so easy to use, but before you do anything you must take your time to
charge the unit for 3 hours before its first use. Even if you want to use it plugged
in straight from the mains, this initial supercharge ensures optimum power
performance to give smooth fast cutting every time. Maximum battery capacity
will only be reached after 3 charging/discharging cycles. A full charge will provide
approximately 2 hours use.
When charging the appliance the blue LED charging light will flash slowly and
continuously until the battery has fully charged, then the blue LED charging light
will stop flashing but remain on.
Mains Operation
• Ensure the appliance is switched off.
• Connect the adaptor to the base of the appliance and plug the adaptor into a
suitable mains socket.
• The blue LED charging light will flash when the adaptor is correctly inserted into
the appliance and connected to the mains.
• The appliance is now ready for use.
• NOTE: The appliance should not be used for longer than 20 minutes when
operated from the mains.
Cordless Operation
• Insert the adaptor into the base of the appliance, plug into a suitable mains
socket and switch on. The blue LED charging light will flash when the adaptor is
correctly inserted into the appliance and connected to the mains.
• Once the appliance is fully charged the blue LED charging light will stop flashing
but remain on, unplug the adaptor from the mains.
2021/10/28 3:39 PM
2021/10/28 3:39 PM
Publicidad
