Publicidad
Idiomas disponibles
Idiomas disponibles
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by Conair Corporation,
the manufacturer of this product and the party responsible for compliance could
void the user's authority to operate the equipment.
FX673N IB-17456.indd 7-8
FX673N IB-17456.indd 7-8
Oiling Instructions
IMPORTANT! It is highly recommended before each use to oil the blades with
the oil provided. This ensures optimum cutting performance. This product is for
commercial use.
For the first use you will need to use the oil supplied with the product, unscrew the
cap and cut off the very end of the plastic tube with a pair of scissors to release
the oil.
To oil the blades ensure the unit is switched on. Gently squeeze the oil tube and
apply 2 drops of oil onto the blades. Leave the unit on for a further few seconds to
allow the oil to thoroughly spread the length of the blades. Switch off the unit and
remove any excess oil by gently dabbing with a cloth.
To oil these
2 positions
Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the
appliance has to be fully discharged every 6 months approximately. Then recharge
the appliance to full capacity, again for 3 hours.
To oil these 2 positions
2021/10/28 3:39 PM
2021/10/28 3:39 PM
Publicidad
