Xylem Flojet BevJet Compact Manual De Instrucciones página 2

Beverage Dispense Pump
CAUTION: This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that
they do not play with the appliance.
Product Data
Specifications
Pump type
Pump electrical ratings
Power supply adapter
Flow rate
Pressure switch shut off
Fluid contact materials
Ports included
Fluid types
(tested with water)
Liquid temperature
Net weight
Application
• Designed for dispensing Bag in Box beverages or Bottled
Water as indicated in Product Data Section
• Ideal for under counter installation
Special features
• Quick, simple, safe installation
• Compact size for easy mounting
• Easily accessible manual on/off switch to restart the pump
• Self priming
• Able to run dry without damage
• Quiet operation
• Built in timer prevents unit from running dry longer than 1
minute
• Built in shut-off automatically turns pump off after 5 minutes
to prevent inadvertant continous operation
Installation
Installation procedure: – See Figure 1
1. Connect suction hose (6.35 mm 1/4") to BIB or Bottle.
2. Connect supplied power adaptor into the DC plug on the back
of the BevJet Compact.
3. Turn the ON/OFF switch located on the pump to the "ON"
position.
4. Open discharge valve to prime pump, and purge all air from
the liquid line.
Operation: – See Figures 1 & 2
Positive displacement diaphragm pump
12VDC 2.5 Amps max
Input: 100-240VAC or 12VDC (BLC9-series) / Output: 12 VDC 3 Amp max
1.0 GPM (3.8 LPM) max
40 PSI (2.8 bar) max
Polypropylene, EPDM, TPV, Stainless Steel
1/4" (6.35 mm) OD Push Fit
Water, soda, syrups, non-pulp juices, iced teas, wine, alcohol beverages < 15%, non particulate fluids,
max viscosity 100cP
34ºF (1.1ºC) - 120ºF (49ºC)
1 lb (632 g)
CAUTION: Do not place BevJet Compact into a
dishwasher as it will cause electrical failure of pump
and controls.
CAUTION: Not intended for outdoor use.
CAUTION: The BevJet Compact must be installed
in an enclosure protected from any splash or spillage.
CAUTION: To avoid exposure to freezing
conditions, prior to storing, cleaning and servicing
of pumps, purge all liquid from the pump. Allowing
water to freeze in the system may result in damage
to the pump and plumbing system.
WARNING EXPLOSION HAZARD: Only
used with specified products. DO NOT PUMP
LIQUIDS WITH A FLASH POINT BELOW 100°F
(37.8°C) OR USE WHERE FLAMMABLE VAPORS ARE
PRESENT.
Figure 1 Typical Beverage Installations
B I
B
2