Publicidad
Idiomas disponibles
Idiomas disponibles
3.5
Electrical connections
3.5.1
Electrical recommendations
Only qualified professionals should carry out electrical connections, always with the
power off. Separate the very low voltage cables from the 230 V circuit cables. The
electrical power supply is done by means of a mains connection cable (~230 V, 50 Hz)
in accordance with prevailing national regulations for electrical installations.
Respect the polarities when making the electrical connections to the mains:
Brown wire (L):
Blue wire (N):
Green/yellow wire:
If the power supply cable is damaged, you must have it replaced by a qualified installer.
The 2.5 mm
2
section power supply cable for the electrical connection of the domestic
hot water tank must be used by the installer.
3.5.2
Electrical recommendations
Connect the power supply; the indicator will light up.
The thermostat will automatically control the temperature. When the water temperature
inside the heater has reached the set temperature, it will switch off automatically, when
the water temperature falls below the set point the heater will be turned on automatically
to restore the heating.
* Electrical plug is in accordance with Spanish and Portuguese safety standards
Line
Neutral
Earth
Power cord *
Fig.6
62
Publicidad
