Tennant T681 Manual De Instrucciones página 22

Double Scrubbing
dirt, scrubbing and drying operations can be performed in
two separate stages.
Prewash with brushes or pads:
- Turn the ignition key to switch the machine on.
- Press the brush button.
- Press the suction motor button: the suction fan
-
- When scrubbing particularly dirty areas, give the
action of detaching and suspending the dirt in the
Drying:
- Press the suction motor button: the suction fan
switches on and the squeegee is lowered
- Pass the machine over the area washed
cleansing action, with the result that subsequent
routine maintenance operations will take much
less time.
Picking up water (without scrubbing)
The machine can be used to mop up spills of water or
Press the suction motor button: the squeegee is lowered
and the suction fan comes into operation.
Proceed to pick up the liquids.
During operation of the machine
- Keep the cleaning passes as straight as possible.
- Overlap successive cleaning passes by a few
centimetres.
- Adjust the ground speed of the machine, the
detergent to suit the type of cleaning. Use the
minimum available settings, as far as practically
possible, for the brush pressure and detergent
- Check the battery charge indicator to ensure
cleaning operation.
- Check the detergent solution level indicator to
ensure that the relative tank is not empty.
- Check the dirty water level indicator to ensure that
the relative tank is not full.
! ATTENTION: do not attempt to clean surfaces on
slopes or gradients steeper than indicated on the
machine data plate.
! ATTENTION: Do not operate the machine on slopes
or gradients steeper than indicated on the data plate.
! ATTENTION: When using the machine on gentle
gradients, do not move transversely across the
slope, but keep the machine on a line parallel to the
direction of the incline, manoeuvring carefully and
without making U-turns.
EN 22