Tennant T681 Manual De Instrucciones página 24

Emptying the dirty water tank
! ATTENTION: before carrying out the operations
When cleaning operations have been completed, empty
the dirty water tank.
If the tank is full, the indicator lights up and the cleaning
functions of the machine will be inhibited; after a few
seconds, the suction motor also shuts down. At this point
the machine must be brought to a halt and the dirty water
tank emptied, following the instructions indicated
-
- Take the machine to the designated service area.
- Unhook the hose from the clip.
- Empty the tank by way of the drain hose: keep
the hose raised initially and remove the plug, then
lower the hose gently and position it over the drain
outlet.
- Rinse the tank with clean water.
-
the directions given in the section "Cleaning the
dirty water tank sensor".
-
hose to the clip.
Emptying the solution tank
! ATTENTION: before carrying out the operations
The detergent solution tank can be emptied by proceeding
as follows:
-
- Take the machine to the designated service area.
- Unhook the hose from the clip.
- Empty the tank by way of the drain hose: keep
below: the hose raised initially and remove the plug, then
lower the hose gently and position it over the drain
outlet.
EN 24