EINHELL TE-SG 18/10 Li Manual De Instrucciones página 12

To fi t the piston rod, proceed in reverse order.
Please note that the piston rod teeth must point
downwards.
6. Operation
6.1 Trigger lever (Fig. 1/Item 1)
The trigger lever (1) can be used in addition for
adjustable control of the tube speed and therefore
its feed. The further you push the trigger lever (1),
the faster the piston rod speed.
Switching on:
Press the trigger lever (1).
Switching off :
Release the trigger lever (1).
6.2 Setting the speed (Fig. 9)
The feed speed can be set by turning the speed
controller (5). Turn the wheel in "+" direction for a
higher speed. Turn the wheel in "-" direction for a
lower speed.
6.3 Note on drip guard function
This tool comes with a drip guard function.
Dripping of the caulk/adhesive is prevented by the
piston rod being retracted slightly, thus releasing
the pressure in the tube.
6.4 Working with the cordless caulk/adhesive
gun
Preparing the surfaces to be sealed
The surface to be sealed must be prepared by
removing any dirt, grease or residues of old
caulk/adhesive that might be on it. The area to be
sealed must be clean and dry.
Note:
It is recommended to apply a thread of silicone on
a piece of paper or cardboard to test the sealant
quantity and the set speed.
•
Check whether the caulk/adhesive tube
holder (7) is properly mounted in place
(section 5.1).
•
Check whether the tube is properly inserted
(section 5.2).
•
Check whether the tip of the tube nozzle has
been cut off and/or that it is not clogged.
•
Set the speed controller (section 6.2) to
setting 1.
•
The tool is now ready for operation.
Anl_TE_SG_18_10_Li_SPK7_USA.indb 12 Anl_TE_SG_18_10_Li_SPK7_USA.indb 12
EN
•
Press the trigger lever (1) to eject caulk/
adhesive.
NOTE:
If the caulk/adhesive thread is too narrow you
must cut the tip of the tube nozzle so that a little
more caulk/adhesive is applied.
Guide the caulk & adhesive gun carefully and
evenly along the surface to be sealed. Make
sure that the caulk/adhesive has contact with
both surfaces to be joined. Use a joint smoothing
trowel or your fi nger to carefully press the caulk/
adhesive into the corners or to fi ll any cracks.
When the tube is empty, the motor will switch off
automatically.
6.5 Charging the Lithium-Ion battery (not
included)
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.6 Battery capacity indicator (Fig. 3 / item
13)
Press the battery capacity indicator switch (14).
The battery capacity indicator (13) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temperature for a day. If the error occurs again,
this means that the battery has been completely
depthdischarged and is defective. Remove the
battery from the device. Never use or charge a
defective battery.
- 12 -
14.06.2023 12:58:52 14.06.2023 12:58:52