Introduction; Manual Purpose And Contents; Target; How To Keep This Manual - Clarke FOCUS II Micro Rider Instrucciones De Uso

ENGLISH

INTRODUCTION

NOTE
The numbers in brackets refer to the components shown in Machine Description chapter.

MANUAL PURPOSE AND CONTENTS

The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and
autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal.
Before performing any procedure on the machine, the operators and qualiied technicians must read this Manual carefully. Contact
Clarke in case of doubts concerning the interpretation of the instructions and for any further information.

TARGET

This Manual is intended for operators and technicians qualiied to perform the machine maintenance.
The operators must not perform procedures reserved for qualiied technicians. Clarke will not be answerable for damages coming
from the non-observance of this prohibition.

HOW TO KEEP THIS MANUAL

The User Manual must be kept near the machine, inside an adequate case, away from liquids and other substances that can cause
damage to it.

IDENTIFICATION DATA

The machine serial number and model are shown on the plate (21) on the steering column.
The machine production year is written in the declaration of conformity and it is also indicated by the irst two igures of the machine
serial number.
This information is useful when requiring machine spare parts. Use the following table to write down the machine identiication data.
MACHINE model ...............................................................................
MACHINE serial number ...................................................................

OTHER REFERENCE MANUALS

– Electronic Battery Charger Manual (an integral part of this Manual, and available upon request)
Moreover, the following Manuals are available:
– Service Manual (that can be consulted at any Clarke Service Center)
– Spare Parts List (supplied with the machine)

SPARE PARTS AND MAINTENANCE

All necessary operating, maintenance and repair procedures must be performed by qualiied personnel or by Clarke Service
Centers. Only original spare parts and accessories must be used.
Call Clarke for service or to order spare parts and accessories, specifying the machine model and serial number.

CHANGES AND IMPROVEMENTS

Clarke constantly improves its products and reserves the right to make changes and improvements at its discretion without being
obliged to apply such beneits to the machines that were previously sold.
Any change and/or addition of accessory must be approved and performed by Clarke.

OPERATION CAPABILITIES

This scrubber-dryer is used to clean (scrubbing and drying) smooth and solid loors, in civil or industrial environment, under safe
operation conditions by a qualiied operator.
The scrubber-dryer cannot be used for itted carpet and carpet cleaning.

CONVENTIONS

Forward, backward, front, rear, left or right are intended with reference to the operator's position, that is to say on the driver's seat
(17).
2
INSTRUCTIONS FOR USE
FOCUS II Micro Rider - 9099236000
7/11