Descargar Imprimir esta página

KitchenBrothers KB4020 Manual De Instrucciones página 45

Barbacoa de gas

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 109
3.2 Connecting the gas cylinder
Note
◊ To use the product correctly, you need a precision-filled standard G30/G31 gas
cylinder with external valve thread. Use a standard flexible hose less than 1.5m
in length. The hose should be easily visible along its entire length for inspection
after installation.
ATTENTION!
◊ You must have the proper regulator and gas cylinder to operate the product
safely and efficiently. Using an incorrect or defective pressure regulator is
dangerous and will void the warranty.
1. Before connecting, check that no debris is stuck in the gas cylinder head, control
valve head or in the burner head and burner ports.
2. Connect the gas line to the gas cylinder by turning the knob clockwise as far as it
will go.
3.3 Disconnecting the gas cylinder
1. Make sure the gas cylinder valve is set to "CLOSED" before disconnecting.
2. Disconnect the gas line from the gas cylinder by turning the knob
counterclockwise until it is loose.
3. After connecting to the gas cylinder, a gas leak test is required.
ATTENTION!
◊ When changing the gas cylinder, make sure you stay away from ignition sources.
3.4 Gas leak test
ATTENTION!
◊ Perform this only from a well-ventilated area.
1. Check that all burner knobs on the product are in the off position.
2. Open the gas valve on the gas cylinder. Check for leaks by brushing soap solution
over all gas system connections with a brush, including all valve connections, hose
connections and regulator connections.
3. If bubbles form on any of the connections, there is a leak.
4. Turn off the gas supply and retighten the connection.
English
45

Publicidad

loading