Toto YT830 Manual De Instrucciones Y Del Propietrario página 5

7) Screw the connecting rods
(matching colors) to the actuator
and leave 3/8" [9mm] from the
surface of the wall.
8) The indicator on the push plate
button frame can be used to adjust
the connecting rods.
9) Use the screws provided to mount the
frame of the push plate to the actuator.
WA RNING: Make sure the connecting
rods go into the square holes.
10) Press the glass face plate into the
frame of the push plate. Flush
the toilet a few times for each
buttons, waiting about 30 sec.
between each flush.
11) To remove the glass face plate,
insert a flat head screw driver on
the bottom right side to snap
open.
Installation Procedure (continued)
!
5
9 mm
9 mm