Bosch Vision 800 Serie Operación, Cuidado Y Instrucciones Para La Instalación página 18

Before Using For
the First Time
To reduce the risk of fire, electric
shock, or injury to persons, read the
IMPORTANT SAFETY
INSTRUCTIONS before operating
this appliance.
The washing machine must be installed
and connected properly (refer to Page
7).
Turn the Cycle Selector to any cycle to
turn the washer on and illuminate the
display. Turn the Cycle Selector to
"Off" to turn the washer off.
Before using your washing machine,
read and follow all installation and
operating instructions.
Using For the First
Time
Setting the time
D The time must be set before other
settings can be made.
You can set the current time. The
settings are retained even if your
washing machine is not used for up to
6 weeks.
Turn the cycle selector to any
cycle.
Example:
Press the Menu button until
"Time:" is displayed. The hours
display flashes.
If no buttons are pushed within 10
seconds the display will revert
back to normal "Ready". Changed
settings will be retained.
Press the Select button until the
hour display is correct.
Press the Menu button until the
minutes display flashes.
Press the Select button until the
minute display is correct.
The time is now set.
Press the Menu button, the menu
function ends.
You can select other settings by
pressing the Menu button and change
them by pressing the Select button.
Selecting the language
The time must be set before the
language can be changed
The cycle selector must not be set
to Off.
Simultaneously press the Menu
and Select buttons and hold down
(5 seconds) until the current
setting is displayed.
Press the Select button until the
desired language is displayed.
Confirm the language selection by
pressing the Menu button.
The language selection can be
confirmed either by pressing the
Menu button or by leaving the
selected language displayed for
five seconds.
Display field
In the first line, the operating and cycle
progress text is displayed at the left.
The current time is displayed on the
right whenever "Ready" is displayed on
the left.
In the second line, the display indicates
the spin speed and the time at which
the cycle is expected to be finished, as
well as symbols for Spin speed,
Washing mode, Pre-Soak, Signal and
Child lock.
First washing cycle
(without laundry)
Your appliance was thoroughly tested
before leaving the factory. A small
amount of residual water may remain in
the washer. To ensure a fresh wash
with your initial load of clothes, first run
the washer a complete cycle, without
any laundry in the drum.
1. Do not load any laundry.
2. Turn on the water faucet.
3. Open the detergent dispenser
drawer.
18