Descargar Imprimir esta página

Bosch Vision 800 Serie Operación, Cuidado Y Instrucciones Para La Instalación página 27

Ocultar thumbs Ver también para Vision 800 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

User Maintenance
Instructions
Cleaning
and Care
To reduce the risk of fire, electric
shock, or injury to persons, read the
IMPORTANT SAFETY
INSTRUCTIONS before operating
this appliance.
Cleaning the detergent
dispenser
If residual detergents or additives have
accumulated or if softener/bleach are
not fully rinsed out:
Pull open the detergent dispenser
drawer. Press down (A) to release
the drawer catch. Remove the
drawer from the appliance.
TO AVOID
RISK OF ELECTRIC SHOCK!
Always disconnect the appliance
from the power outlet before
cleaning.
Never clean the washing machine
with a pressure washer.
TO AVOID
RISK OF EXPLOSION!
Never use flammable solvents to
clean the appliance.
Remove the liquid detergent insert
by pulling it upwards from the
detergent drawer.
Cleaning the appliance
housing and control
panel
As required:
Use hot, soapy water or a mild,
non-abrasive cleaning agent.
Dry with a soft towel.
Cleaning
the drum
If rust spots have formed due to
left-over debris (e.g. coins, paper clips,
nails):
Use a chlorine-free cleaning agent.
Follow the manufacturer's
instructions. Never use steel wool.
Reinsert the liquid detergent insert
if using liquid detergent. Slide the
detergent dispenser drawer back
into place and close it completely.
D
DO NOT operate the washer
without
the detergent
drawer in
place and fully closed!
Cleaning water inlet
strainers
This is necessary if very little or no
water flows into the washing machine.
Cleaning is recommended every 6
months to reduce valve blockage in
areas using hard water.
First release
the water
pressure
in the supply
hoses:
Turn off the water faucets.
Turn the cycle selector to any
warm cycle.
Press Start/Pause
button and
wait for 30 seconds.
Turn the cycle selector to Off.
Cleaning
the Door Gasket
After washing, wipe the gasket to
remove residual water or detergent.
Mold or odor issues can result if water
or detergent is allowed to remain on the
gasket.
Allow the drum to air out after
washing by leaving the door
partially open. This will allow air to
circulate and help dry out any
remaining moisture in the drum or
on the gasket.
Clean the detergent dispenser by
inserting it under warm running
water. Lightly wipe away any
remaining detergent residue.
27

Publicidad

loading