Descargar Imprimir esta página

Bosch Vision 800 Serie Operación, Cuidado Y Instrucciones Para La Instalación página 26

Ocultar thumbs Ver también para Vision 800 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

During Washing
The washer drum system may
experience
a slight shudder or
shake as the drum accelerates
to higher spin speeds due to
normal laundry imbalance.
Re-selecting
a cycle
If Child lock is active, temporarily
deactivate it (see page 25).
Turn the cycle selector to Off.
Turn the cycle selector to a newly
selected cycle.
:::
B
s_
P_ogr_
The Start/Pause
indicator light
flashes.
If required, change the settings.
(see Page 25).
Press the Start/Pause
button.
The cycle starts.
Add a garment
/
Interrupting
the cycle
You can put laundry in the drum after
washing begins, take laundry out of the
drum early or interrupt the cycle at any
time.
It is not recommended to add
laundry after the washing phase is
complete.
Without
Child lock
You can add or reduce laundry as
long as the Start/Pause
indicator
light flashes and it is safe to do so.
Press the Start/Pause
button.
The following displays are
indicated in succession:
"Pause",
"Door can be opened".
Open the door.
Add/remove the laundry.
Close the door.
Press the Start/Pause
button.
The cycle continues.
The indicator light is lit.
When the Start/Pause
indicator
light is illuminated, the cycle can
be interrupted, however in some
cases the door will not be
unlocked for safety reasons (high
water level, water temperature or
drum speed).
If the speed is too high, the
Start/Pause
indicator light is
illuminated. Laundry can be added
in "Pause" mode when the drum is
at a standstill.
Child lock activated
Refer to the Child lock section,
(see page 25).
Canceling
the active cycle
If you would like to terminate a cycle
and remove the laundry:
Press the Start/Pause
button
If Child Lock is active, it is
necessary to press and hold down
the Start/Pause button for five
seconds
If the load is too wet, turn the cycle
selector to Drain/Spin
and run the
cycle using a spin speed
appropriate for the laundry type
(see pg. 22 for suggested spin
speeds).
If a cycle is interrupted at a high
temperature, the door will remain
locked until the temperature in the
drum has cooled down.
If the cycle is terminated by
switching the appliance to "Off ",
the door will may remain locked
until the appliance is switched
back on. Turn the cycle selector
to any other cycle. The door will
unlock after approximately 5
seconds.
After Washing
The Start/Pause
indicator light turns
off.
Display field: "Remove laundry".
Open the door.
Turn the cycle selector to Off.
Close the faucets.
Remove the laundry.
To avoid the risk of rust, check for
foreign objects (e.g. coins, paper
clips) between the drum and rubber
door seal.
DAfter
washing, leave the washer
loading door open for 24 hours to
allow the inside of the washing
machine to dry.
26

Publicidad

loading