eufy Security eufyCam E330 Professional Guia De Inicio Rapido página 7

SAFETY
• The suitable temperature range for E330 eufyCam (Professional) and
accessories is -20°C to 45°C (-4°F - 113°F). The recommended temperature
range for devices and accessories is 5°C to 25°C (41°F - 77°F).
• Unless specifically indicated that it is safe to do so in the user guide or
instruction manual, do not use this device in an environment that exceeds the
recommended low or high temperature.
• Unless specifically indicated that it is safe to do so in the user guide or
instruction manual, avoid exposing your device to direct sunlight or wet
environments.
• The power adapter should be installed near the equipment and should be
easily accessible.
• Use only a power adapter supplied by or approved by the manufacturer.
Using an unauthorized power adapter may cause danger and may violate the
authorization of the device to receive service under warranty.
• The power adapter is for indoor use only. The plug is considered as a
disconnect device of the adapter.
09 EN
NOTICE
NOTICE (Europe and United Kingdom)
This product complies with the radio interference requirements
of the European Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this device is in
compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EU. For the declaration of conformity,
visit the website: https://uk.eufylife.com.
RF exposure information:
The Maximum Permissible Exposure (MPE) level has been calculated
based on a distance of d=20cm between the device and the human
body. To maintain compliance with RF exposure requirement, use
products that maintain a 20cm distance between the device and
human body.
Frequency bands and power as below:
Function Bands Operation Frequency
Wi-Fi for T8600 2.4GHz 2412-2472MHz
The adapter type (for T8600) is TEKA-TB120100XX, rated output
voltage/current is 12Vdc/1A.
The following importer is the responsible party (contract for EU
matters):
Anker Innovations Deutschland GmbH I Georg-Muche-Strasse 3, 80807
Munich, Germany
The following importer is the responsible party (contract for UK
matters):
Anker Technology (UK) Limited I GNR8, 49 Clarendon Road, Watford,
Hertfordshire, WD17 1HP, United Kingdom
Max. Power
EIRP 19.15 dBm
EN 10