Publicidad
Idiomas disponibles
Idiomas disponibles
DEVICE INSTALLATION
1) Make sure the main switch is set to the OFF position
2) Connect the device based on the diagrams provided
3) Turn the main switch to the ON position
4) Include the device in the Z-Wave
TIP: The antenna must not be shortened, removed or
modified. To ensure maximum efficiency, it must be
installed as shown. Large size metal equipment near the
antenna can negatively affect reception. Each device is a node
in a mesh network. If there are metal obstacles, the obstacle
can often be overcome with a further triangulation node.
LED STATUS INDICATOR
The system includes an RGB LED that shows the device's status during installation:
Solid RED: the device is not included in any network
Solid BLUE: the device is Offline setup mode
4 GREEN blinks then OFF: the device has been just added to a Z-Wave
S2 Authenticate Mode
4 BLUE blinks then OFF: the device has been just added to a Z-Wave
Unauthenticated Mode
4 RED blinks then OFF: the device has been just added to a Z-Wave
security
Sequence of GREEN-BLUE Learn Mode for inclusion
Sequence of RED-BLUE Learn Mode for exclusion
Rapid sequence of GREEN-BLUE-RED: the event on the input (external switch) is
not valid.
TIP: To test if the electrical connections are correct, before the inclusion of the
device, while pressing n times the external switch, the RGB LED should flash
green for the same amount of times. If it does not, check the wire connections.
network
TM
29
network in
TM
network in S2
TM
network without
TM
Publicidad
