DeLOCK 64252 Manual Del Usuario página 5

English
Clone Function without PC
1.
Install an M.2 SSD as described above.
2. Connect your SATA 22 pin device to the converter.
3. Connect the power supply to the DC jack of the converter and plug the power
supply into a power outlet.
4.
Switch on the converter.
5.
The LED on the appropriate slots lights up.
6.
Set the switch to the required copy mode on the converter.
7. M.2 to SATA (source: M.2 – target: SATA)
8. SATA to M.2 (source: SATA – target: M.2)
9. Press the clone button for about 3 - 5 sec. in order to activate the clone
process.
10. The four blue LEDs lights up.
11. Press the clone button again briefly.
12. The LED indicator shows the copy status.
13. The copy process is completed as soon as all LEDs light up blue.
Support Delock
If you have further questions, please contact our customer support
support@delock.de
You can find current product information on our homepage: www.delock.com
Final clause
Information and data contained in this manual are subject to change without
notice in advance. Errors and misprints excepted.
Copyright
No part of this user manual may be reproduced, or transmitted for any purpose,
regardless in which way or by any means, electronically or mechanically, without
explicit written approval of Delock.
Edition: 09/2023
-5-