Andis CLC-5 Manual De Instrucciones página 7

REPLACEMENT (REMOVAL) OF BLADE SET
When removing the blade, turn the clipper OFF. Push the blade away from the clipper
with your thumb, and the blade will pop off (Figure C). To replace or change the blade
set, first slide the length setting to the 1.9mm mark. Then, fit the black plastic tab on
the blade set into the notch located at the bottom of the clipper opening. Firmly push
the blade into the clipper housing and it will snap into place (Figure D).
BLADE TEMPERATURE
Due to the high speed nature of Andis clippers, please check for blade heat often,
especially on close-cutting blades. If blades are too hot, dip the blades only into
Andis Blade Care Plus or apply Andis Cool Care Plus and then Andis Clipper Oil.
CARE AND SERVICING OF YOUR ANDIS CLIPPER BLADES
Blades should be oiled before, during, and after each use. If your clipper blades
leave streaks or slow down, it's a sure sign that the blades need oil. Hold the clipper
with the blades pointing down to prevent oil from getting into the motor. Place a few
drops of Andis Clipper Oil on the front and side of the cutter blades (Figure E). Wipe
excess oil off blades with a soft dry cloth. Spray lubricants contain insufficient oil for
good lubrication, but are an excellent clipper blade coolant. Always replace broken or
nicked blades to prevent injury. You can clean the excess hair from your blades by
using a small brush or worn out tooth brush. To clean the blades, we suggest to
immerse the blades only into a shallow pan of Andis Blade Care Plus while the
clipper is running. Any excess hair and dirt that has accumulated between the blades
should come out. After cleaning, turn your clipper off, wipe off excess solution and
start clipping again.
For more information on how to care for your clipper and view how-to tutorials,
visit andis.com/BarberStylistEducation/Books
WARNING: Cutting blades may become hot after prolonged use.
7