Publicidad
INSTALLING THE GRASS BAGGER (Fig. C3-C8)
EN
C3-1
U-shaped Bracket
4 Sets of Bolts & Nuts
C3-2
(M8 X 40)
C4-1
Side Brackets
C4-3
Combination Wrench
1 set of bolt & nut
C5-2
(M8 X 40)
C6-1
Bagger Support Brackets C6-2
C6-3
Combination Wrenches
C7-2
2 Nuts (M8)
ADJUSTMENT
BEFORE ADJUSTMENT (Fig. D1)
ADJUSTING THE CUTTING-DECK HEIGHT (Fig. D2)
ADJUSTING THE ANTI-SCALP WHEELS (Fig. D3 – D6)
D3-1
Anti-Scalp Wheels
D5-2
Lug Bolt
ADJUSTING THE SEAT (Fig. D7)
D7-1
Seat Position Adjustment Lever
OPERATION
BEFORE OPERATION (Fig. E1)
SETTING THE PARKING BRAKE (Fig. E2)
E2-1
Parking-Brake Position
WARNING: THE PARKING-BRAKE PEDAL CANNOT SLOW DOWN
THE DRIVING SPEED. NEVER TRY TO DEPRESS THE PARKING-BRAKE
PEDAL TO SLOW DOWN THE DRIVING SPEED DURING DRIVING. WHEN
THE PARKING-BRAKE PEDAL IS DEPRESSED BUT IS NOT ENGAGED IN
THE PARKING-BRAKE POSITION, THE ELECTRIC BRAKE IS NO LONGER
EFFECTIVE AND THE TRACTOR WILL STOP MOVING ON A FLAT SURFACE.
BUT IF THIS HAPPENS ON A SLOPE, THE TRACTOR MAY SLIDE DOWN
THE SLOPE ONCE THE PARKING-BRAKE PEDAL IS RELEASED.
WARNING: PULL UP THE PARKING-BRAKE LOCK LEVER AND DEPRESS
THE PARKING-BRAKE PEDAL IMMEDIATELY TO ENGAGE IT IN THE PARKING-
BRAKE POSITION IN CASE ANY EMERGENCY OCCURS, THE TRACTOR WILL
STOP IMMEDIATELY AND WILL NOT SLIDE DOWN THE SLOPE.
ATTACHING / DETACHING THE BATTERY PACK (Fig. E3 – E6)
In order to start this tractor, EGO batteries totaling 15 Ah
(2 X BA4200/BA4200T) or more are required. For best performance, we
recommended use of EGO batteries that total 30 Ah or more.
20
ELECTRIC LAWN TRACTOR — TR3800E-B
C3-2 Bagger
C3-4 Combination Wrench
4 Sets of Bolts & Nuts
C4-2
(M8 X 40)
C5-1 Tipping Lever
C5-3 Combination Wrench
4 Sets of Bolts & Nuts
(M8 X 25)
C7-1 Cross Bar
C7-3 Combination Wrenches
D5-1
Nut
D6-1
Deck Height Label
E2-2
Released Position
E3-1
Cover Release Button
CHARGING THE TRACTOR
Use only with the recommended battery packs and chargers.
◾
Charge the battery pack(s) separately (Fig. E7)
NOTICE: Refer to corresponding battery and charger manuals for
detail instructions.
◾
Charge the battery pack(s) via charging port (Fig. E8-E10)
E10-1
Dust Cap
TESTING THE SAFETY INTERLOCK SYSTEM
a. To test the deck-blade system (Fig. E11 – E12)
b. To test the driving system (Fig. E13 – E14)
If the deck-blade system and/or the driving system fails to stop when
the operator is off of the seat and if the cause cannot be determined
after confirming the plug and socket connection of the seat is well
connected, contact your EGO customer service center immediately.
COMMUNICATION TECHNOLOGY
For information on our full range of connected products and services,
including connection instructions, please scan QR Code below or visit
www.egopowerplus.eu/connect.
CHECKLIST BEFORE OPERATION
◾
Ensure that the work area is clear of children, bystanders, and
pets.
◾
Clear the work area of objects that may be thrown by the tractor
blades.
◾
Clean debris from the tractor.
◾
Check for loose fasteners.
◾
Check to make sure that all guards are in place and working
properly.
◾
Visually check the tires whether they are inflated.
◾
Check the brake operation.
◾
Adjust the deck height to the desired cutting position best suited
for the lawn, and adjust anti-scalp wheels accordingly.
◾
Adjust the seat position and make sure both pedals can be reached.
◾
Verify the battery charge level.
◾
Test the safety interlock system.
◾
Ensure the grass bagger is installed properly.
E5-1
Battery Release Button
E10-2
Charging Port
Publicidad
