Publicidad
LCD
Description
Display
The alert icon blinks
The icons of each
occupied battery
compartment and alert
icon blink every 1 second
at the same time on the
LCD screen.
The icon of each
occupied battery
compartment and alert
icon blink every half a
second.
CCS icon illuminates on
the LCD screen
CCS icon blinks on the
LCD screen.
No bagger icon
illuminates on the LCD
screen
Full bagger icon blinks on
the LCD screen
Tractor Status
Audio
Cause
Indicator
Indicator
The blade motor is overloaded.
The side discharge chute is
Flashes red
One beep
clogged with grass and debris.
There is an interference
between the blade and the
tractor deck.
Keeps
beeping
The battery packs are low on
until the
Flashes red
charge and the tractor is in
PTO switch
Limp Home mode.
is pushed
downward.
The blade motor was
Keeps
interrupted in operation and
Flashes red
beeping
the PTO switch is not set to off
position.
The tractor continues forward
at a set speed without needing
Solid green
No
to step on the accelerator
pedal.
The CCS (cruise control
system) function has failed.
OFF
No
Parking-brake pedal is
depressed to stop the tractor.
It indicates the grass bagger is
n/a
No
not mounted onto the tractor or
is not mounted properly.
It indicates the grass bagger
n/a
No
is full.
Solution
Raise the deck cutting height or slow the
driving speed to reduce the load of the
tractor.
Clean the side discharge chute after
each use.
Call EGO Customer Service Center
Stop working and return to the battery
charging area.
NOTE: When the tractor is in Limp-Home
mode, the blades are automatically
switched into low rotation speed and
meanwhile the audio indicator will keep
beeping. The operator should push the
PTO switch downward to turn off the
blade motors. The audio indicator will
stop beeping after the blades stop.
The tractor will stop working
immediately. The operator should
transport the tractor to the battery
charging area for charging.
This is normal operation. If needed,
turn the CCS function off following the
section "To stop (exit) Cruise Control
(CCS)" in the manual.
The CCS function could not be set when
the tractor is driving at very low speed
or is driving in reverse.
After the parking-brake pedal is
released, press the CCS button and the
CCS icon will illuminate on the LCD,
or exit the CCS function following the
instructions in the section "To stop
(exit) Cruise Control (CCS)".
Mount the grass bagger onto the tractor
properly.
Empty the grass bagger and replace it
properly.
ELECTRIC LAWN TRACTOR — TR3800E-B
EN
31
Publicidad
