AEG NIK95I00FB Manual De Instrucciones página 67

PowerSlide
This function allows you to adjust the
temperature by moving the cookware to a
different position on the induction cooking
area.
• The function divides the induction cooking
area into three areas with different heat
settings. The hob detects the position of
the cookware and adjusts the heat setting
corresponding with the position.
• You can place the cookware in the front,
middle or rear position. If you place the
cookware in the front you get the highest
heat setting. To decrease it, move the
cookware to middle or rear position.
• When you activate the function for the first
time you will get the following default heat
settings: 9 for the front position, 6 for the
middle position and 3 for the rear position.
• You can change the heat settings for each
position separately. The hob will
remember your heat settings next time
you activate the function.
• The heat setting display of the left front
control bar shows the heat setting for this
function. To change the heat setting use
the left front control bar only. The left
rear control bar is deactivated while the
function operates.
Use only one pot with a minimum bottom
diameter of 160 mm when you operate
the function.
1. Place the correct cookware on the left
front side of the cooking area.
2. Press and hold
A signal sounds and indicators above
appear.
3. Press to activate the function.
A signal sounds and an indicator above the
symbol appears.
4. Move the cookware back and forth on the
cooking area as needed. To change the
position of the cookware lift it up and
place it on a different part of the area. Do
not slide the cookware as it may cause
scratches and discolouration of the
surface.
The heat setting level on the control bar
adjusts automatically.
5. To change the default heat setting levels,
move the cookware to the area you want
to adjust first.
6. Press any of the available heat setting
levels on the left front control bar.
The updated heat setting levels will be
remembered for the next time you use the
function.
7. Repeat the procedure for the remaining
cooking areas, if needed.
8. To deactivate the function, press
can also press 0 on the left front control
bar.
A signal sounds and the indicator above the
symbol disappears. The heat setting level
changes to 0.
You can set a timer while PowerSlide
operates. In this case the timer does not
deactivate the cooking zones when the set
time runs out. The timer affects all three
cooking areas activated by the function at the
same time.
to activate the hob.
and
. You
ENGLISH 67