Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
6. Attaching the front panel with control button
• Locate the Front Panel with Control Button (EA).
• Using Screws (EE), secure the Front Panel with
Control Button (EA) between the Left and Right
Inside Panels and just below the Top Surround
Rail as shown.
Hardware Used
Ø3.5x12mm
EE
Screw
7. Placing the glass front
• With an assistant, carefully turn the unit over onto
it's back side.
• Turn the unit over so that Control Panel Support is
now facing upward.
• Locate the Glass Panel (F).
• Carefully insert the Glass Panel (F) into the
grooves of the surround rails as shown. Slide all
the way in until the glass meets the bottom of the
Control Support Panel.
8. Constructing the Base
• Attach Frame Rails (I) to Base (A).
• Locate Frame Rails (I) and Base (A).
• Align the pre-installed screws on the Frame Rails
(I) with the screw holes on the bottom of the Base
(A).
• After inserting the screws into the holes,
tighten the fasteners using a Phillips Screwdriver
as shown.
23MMP35115REV1.0
x 5
11
6
EA
7
8
I
F
I
A
Publicidad
