Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
21. Connecting the fireplace wiring
• Connect Key Button Connection Wire to heater.
• Insert the Ember Bed Connection Wire into the
heater.
• Route the Ember Bed Connection Wire down the
side surround rail and along the back of the log
set, securing it in place with the clips as shown.
22. Placing the fireplace back panel
• Locate the Electric fireplace back panel (H).
• Slightly bend the back panel to fit into the grooves
behind the log set.
• Note that this back panel is reversible and can be
placed with either side facing the fireplace insert
for a customizable look.
23. Securing the fireplace background
• Place the Back Panel Brackets (KK) between the
Wallpaper and the grooves of the assembly as
shown.
• Fasten each Back Panel Bracket (KK) using
Screws (JJ). Repeat until all brackets are in place
as indicated by the diagram.
Hardware Used
Ø3x16mm
JJ
Screw
Back Panel
KK
Bracket
23MMP35115REV1.0
x4
16
21
Key Button
Connection Wire
Ember Bed
Connection Wire
22
23
H
Publicidad
