Descargar Imprimir esta página

Hotpoint Ariston FZ 61 P.1 IX/HA Manual De Instrucciones página 20

Ocultar thumbs Ver también para FZ 61 P.1 IX/HA:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
Maintenance and care
Switching the appliance off
GB
Disconnect your appliance from the electricity
supply before carrying out any work on it.
Cleaning the appliance
• The stainless-steel or enamel-coated external
parts as well as the rubber seals may be cleaned
using a sponge that has been soaked in
lukewarm water and neutral soap. If these stains
are difficult to remove, use only specialised
products. After cleaning, rinse and dry
thoroughly. Do not use abrasive powders or
corrosive substances.
• Ideally, the inside of the oven should be cleaned
after each use, when it is still lukewarm. Use hot
water and detergent, rinse and dry with a soft
cloth. Do not use abrasive products.
• The accessories can be washed like everyday
crockery (even in your dishwasher).
! Never use steam cleaners or pressure cleaners on
the appliance.
Cleaning the oven door
Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crack. To clean more thoroughly, you can remove
the oven door.
20
1. Open the oven door fully
( see diagram )
2. Lift up and turn the small
levers located on the two
hinges ( see diagram )
3. Grip the door on the two
external sides and close it
approximately half way.
Pull the door towards you
lifting it out of its seat ( see
diagram ).
To replace the door, reverse
this sequence.
Inspecting the seals
Check the door seals around the oven periodically. If
the seals are damaged, please contact your nearest
After-sales Service Centre ( see Assistance ). We
recommend not using the oven until the seals have
been replaced.
Replacing the light bulb
To replace the oven light bulb:
Oven
compartment
Lamp
Seal
Glass door
1. Remove the glass lid using a screwdriver.
2. Remove the light bulb and replace it with a similar
one: Wattage 15 W, cap E 14.
Replace the glass cover taking care to position the
seal correctly ( see diagram ).

Publicidad

loading