Cameo PIXBAR G2 Manual De Usuario página 26

VERTICAL FLOOR MOUNTING
For vertical floor mounting, a maximum of two
PIXBAR G2 may be connected to each other.
®
The following optionally available products must
be used for this:
1 One connector (item number CLPBG-
2STACKKIT).
2 One stop set (article number CLPBG2VERTI-
MOUNT).
3
One M20 connection set (article number
CLPBG2M20ADA).
4 A heavy steel stand with M20 thread and
sufficient stability for the total load.
The stability in combination with the stand used
must be assessed by the user. No additional
loads may be introduced.
For optical reasons, the mounting feet can be
folded to the side of the housing. A rubber buffer
prevents the surface from being damaged.
FROST FILTER
A standard frost filter is included with the PIXBAR
holder (1) of the bar, open the sliding latch at one end of the bar (2, slide down the handle). After
inserting the frost filter into the holder, close the latch again to prevent the filter from falling out.
26
1
2
G2. To insert the frost filter into the provided
®
1
2
3
4