Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
This tool is intended for dry sanding of wood,
plastic, filler and coated surfaces.
For good collection efficiency, please NOT
USE your tool on wet workpiece surface.
1. FITTING THE SANDING PAPER
SANDING PAPER WITH HOOK & LOOP
SYSTEM
FIT THE SANDING PAPER (SEE FIG A)
The sanding papers are placed directly onto the
base plate. The hole pattern in the
base plate and sanding paper must match. Then
press the sanding paper onto the base
plate by hand. Firmly press the power tool with
the sanding paper against a flat surface
and briefly switch the power tool on. This
provides for good adhesion and prevents
premature wear.
Before placing on the sanding paper, free the
base plate from dust/debris by lightly
tapping against it.
REMOVE THE SANDING PAPER
Simply remove the sanding paper directly.
A
SANDING PAPER WITHOUT HOOK & LOOP
SYSTEM (SEE FIG B , C , D)
FIT THE SANDING PAPER
Fit the sanding paper over the base. Make sure
the sanding paper is even with the
edges and that the dust collection holes in the
base and sanding paper is aligned and
that the sanding paper is taut on the base.
Lift the sanding paper retaining clips to the open
position and insert one end of the
30
sanding paper under the retaining clip.
Push the clip back into the retaining position.
Lightly stretch the paper over the base
plate ensuring that it is not folded or wrinkled
then position under the other retaining
clip back into the retaining position. Check that
the paper is flat to the base plate,
if not, release either clip and reposition the paper
before resetting the clip. Switch
on momentarily to check that the sander is
functioning correctly. If there is undue
vibration, repeat the paper positioning procedure.
REMOVE THE SANDING PAPER
To remove the sanding paper, lift up the clamp
lever and move away from the clamp
lever lock. The sanding paper clamp is now
loose. Repeat with the other clamp on the
opposite side of your sander.
B
C
D
Publicidad
