GreenWorks GD60BCB Manual Del Operario página 12

IMPORTANT
Use only the replacement parts and accessories of
the initial manufacturer.
6.1 GENERAL INFORMATION
IMPORTANT
Only your dealer or approved service center can do
the maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Use correct clothing, protective gloves, and safety
glasses.
6.2 CLEAN THE MACHINE
• Clean the machine after each use with a moist cloth
dipped in neutral detergent.
• Do not use aggressive detergents or solvents like
"glass cleaner" to clean the plastic parts or handles.
• Keep the trimmer head free from grass, leaves, or
excessive grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage of the motor.
• Do not spray water onto the motor and electrical
components.
6.3 REMOVE ANY REMAINING LINE
Figure 14 - 16.
1. Simultaneously press the tabs on the sides of the
trimmer head.
2. Remove the spool cover and the spool.
3. Remove any remaining line.
4. Put the spool into the spool housing.
5. Install the spool cover onto the trimmer head.
6. Push the spool cover until it clicks into position.
6.4 INSTALL THE CUTTING LINE
Figure 17 - 21.
Do not put more than 15 feet of cutting line in at a
time.
1. Line up the slots on the spool cap with the slots
on the trimmer head.
2. Put the cutting line through the hole. Push the
cutting line until it exits the opposite hole.
3. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
English
NOTE
4. Turn the spool cap clock-wise to wind the cutting
line into the trimmer head. Keep approximately 5
in of cutting line above out of each side of the
trimmer head.
6.5 REMOVE THE TRIMMER HEAD
Figure 22 - 23.
1. Put the metal rod in the specified angle
transmission hole to fix the trimmer head.
2. Turn the trimmer head clockwise to loosen it. Do
not remove the spacer from the shaft.
6.6 ASSEMBLE THE BRUSH CUTTER BLADE
Figure 24 - 25.
Wear gloves and be careful with sharp edges.
Apply the guard to the blade.
Use the specified Nylon locknut which is packed with
the blade, to assemble the blade.
You must change the locknut after you use it for 20
times.
1. Put the metal rod in the specified angle
transmission hole to fix the trimmer head.
2. Put the brush-cutter blade on top of the inner cup.
Make sure the blade is in the center.
3. Put the outer cup above the plate.
4. Put the locknut above the outer cup.
5. Tighten the lock-nut counter-clockwise to 44-58"
N.M of torque with a 19mm wrench.
6.7 REMOVE THE BRUSH-CUTTER BLADE
Figure 26 - 28.
Apply the guard to the blade.
1. Put the metal rod in the specified angle
transmission hole to fix the trimmer head.
2. Loosen the nut clockwise and remove the outer
cup.
3. Remove the brush-cutter blade.
7
WARNING
WARNING
WARNING
WARNING
WARNING
EN