Braun KF6031 Instrucciones página 10

English
Our products are engineered to meet the highest
standards of quality, functionality and design.
We hope you thoroughly enjoy the new Braun
appliance.
Before Use
Please read instructions carefully and
completely before using the appliance.
Description of Parts and Accessories
1 On/Off button
2 LED control panel and clock
3 Water reservoir incl. water level indicator
(inside)
4 Filter basket with anti drip system
5 Gold tone permanent filter
6 Reservoir cover and showerhead
7 Charcoal water filter
8 Charcoal water filter holder
9 Keep warm plate
10 Cord storage
11 Glass carafe
12 Flip lid (glass carafe)
13 Coffee measuring scoop
14 Thermal mug
Maximum water capacity: 12 cups (60 fl. oz.)
LED Control Panel
a. BREW
Use to start the brew and keep warm cycles.
b. AUTO ON
Use to program the start time of the brew cycle.
The AUTO ON time can be set for any time, day
or night. «PM» is displayed on the LED for
nighttime program times.
c. AUTO OFF
Use to program the shut off time of the coffee
maker.
d. CLOCK
Displays time of day and use to set time for
automatic functions (auto on and auto off times).
e. SET
Use to program the time of day, auto on, auto off
times and water hardness level.
f. CLEAN
Use to activate the descaling mode and set the
water hardness level.
g. 1-4
Use to brew smaller amounts of coffee (up to
4 cups).
10
OPERATING INSTRUCTIONS
Installing the Charcoal Water Filter (A)
Use of the charcoal water filter is optional, but
strongly recommended. The filter eliminates
chlorine, bad tastes and odors from tap water.
The coffee maker will operate normally without it.
Replacement water filters can be purchased in
stores, through the Braun website, or by calling
Customer Service.
• Remove the charcoal water filter (7) from polybag
and soak in cold tap water a minium of 15
minutes.
• Remove the charcoal water filter holder (8) from
the coffee maker by lifting it out of the water
reservoir (3).
• Gently press down the stem and pull toward you.
Compartment will flip open.
• Place the charcoal water filter in the water filter
holder and close it; you will hear a snap indicating
it is in place.
• Hold the filter under cold running tap water for
10 seconds to flush. You should place the hole
openings directly under the water stream.
• Allow the filter to drain completely.
• Position the green indicator to the month you
installed the charcoal water filter. We recommend
changing the charcoal water filter every 2 months,
more often if you have hard tap water.
• Replace the charcoal water filter holder in the
water reservoir of the coffee maker, pushing it all
the way down to the base of the unit, along the
reservoir wall.
NOTE: Caution must be used when inserting the
charcoal water filter. Improper placement in the
water filter holder can cause tearing of the filter
skin.
Switching On/Off
• To switch on the coffee maker, press the On/Off
button (1). The green indicator light will illuminate
indicating that the coffee maker is in «ready»
mode.
• To switch off the coffee maker, press the On/Off
button again. The green indicator light will turn off
indicating that the coffee maker is in «stand by»
mode.
Programming the Coffee Maker
NOTE: The coffee maker features a 60-second
power loss back-up system that remembers all
programmed information, including time of day and