dirna Bergstrom TRP Dynamic Instrucciones De Montaje página 18

TRP Dynamic
EN
Assembly
Recommendations
• Before starting assembly, please read instructions and
follow them during installation process.
• Use the adequate tools for each operation.
Electricity
• Disconnect ignition key.
• Disconnect battery before starting assembly.
• Make sure electric components are securely connected,
checking their correct fitting.
! Warning
If, during assembly, the unit becomes slanted or
the cabin drops with the unit mounted, wait for
at least 60 minutes from the moment the unit is
horizontal before starting up.
Documentation included
Mounting instructions
User's guide
Troubleshooting
Warranty
Indications concerning position are:
RIGHT: Passenger side
LEFT: Driver side
Driving torques (N.m)
Steel Quality
Fillet
8.8
M6/100 10
Hoses assembly
Driving torques (N.m)
Hose size
1/4"
3/8"
220.AA6.5030
220.AA6.4002
220.AA6.4003
220.AA1.0010
Wrench
opening
10.9
13 10
Fitting
Driving Tool
Torque
13-15 Wrench 14mm.
15-17 Wrench 19mm.
Ratchet wrench of 10
Cruciform screwdriver TOP 10
Wrench of 10, 11, 14, 17, 19
Allen key of 6
Socket wrench of Ø10
Broach Ø 4
Drill
Broach Ø 6
Circular saw Ø 19, 22, 48
Scissors
Riveter M6
Fragile
Beware of cuts!
Electrical hazard
!
The installing personnel must have a sufficient training
in vehicles air conditioning.
!
dirna Bergstrom, s.l. shall not be responsible for
breakdowns or damages coming from an inadequate
handling or installation of the equipment or from
modifications and substitutions carried out without our
express and written authorisation.
!
Amount of refrigerant gas load R-134a to be
introduced in the circuit: 300 g.
!
Please see product warranty procedure included in
Troubleshooting.
!
Please see equipment User's Guide for its correct
functioning of the remote control and control panel.
!
Once installation is finished, the following documents
must be handed over to the user: User's Guide,
Warranty and Troubleshooting.
18
Air conditioning for vehicles
Tools
Symbology
!
Warnings