Functional Description - Milwaukee 2146-20 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SPECIFICATIONS
Cat. No. ..................................................... 2146-20
Ingress Protection............................................ IP54
Max Number of Lights in Sequence ....................12
Battery Type .................................................M18™
Charger Type ................................................M18™
DC Input Volts......................................................18
DC Input Amps ...................................................2.5
AC Input Volts ....................................................120
AC Input Amps.......................................................1
AC Output Volts .................................................120
AC Output Amps ................................................ 11 *
* Reduce AC Output Amps by 1A per additional
light added in sequence.
SYMBOLOGY
Volts
Direct Current
Alternating Current
UL Listing for Canada and U.S.
C
US
CAUTION
Do Not Stare Into Light

FUNCTIONAL DESCRIPTION

2
1
9
8
1. Area selector
2. Power
3. Brightness selector
4. Battery bay
5. AC input
Bright Light -
3
7
6
6. ONE-KEY indicator
7. Rafter hook
8. AC output
9. Handle
10. Security cable (not shown)
DANGER
electric shock. Check with a qualified electrician
if you are in doubt as to whether the outlet is
properly grounded. Do not modify the plug pro-
vided with the tool. Never remove the grounding
prong from the plug. Do not use the tool if the
cord or plug is damaged. If damaged, have it
repaired by a MILWAUKEE service facility before
use. If the plug will not fit the outlet, have a
proper outlet installed by a qualified electrician.
Grounded Tools (Three-Prong Plugs)
Tools marked "Grounding Required" have a three
wire cord and three prong grounding plug. The plug
must be connected to a properly grounded outlet
(See Figure A). If the tool should electrically mal-
function or break down, grounding provides a low
resistance path to carry electricity away from the
user, reducing the risk of electric shock.
The grounding prong in the plug is connected through
the green wire inside the cord to the grounding
system in the tool. The green wire in the cord must
be the only wire connected to the tool's grounding
system and must never be attached to an electrically
"live" terminal.
Your tool must be plugged into an appro-
priate outlet, properly installed and
grounded in accordance with all codes
and ordinances. The plug and outlet
should look like those in Figure A.
Double Insulated Tools (Two-Prong Plugs)
Tools marked "Double Insulated" do not require
grounding. They have a special double insulation
system which satisfies OSHA requirements and
complies with the applicable standards of Underwrit-
4
ers Laboratories, Inc., the Canadian
Standard Association and the National
Electrical Code. Double Insulated tools
may be used in either of the 120 volt
outlets shown in Figures B and C.
5
3
GROUNDING
Improperly connecting the ground-
ing wire can result in the risk of
Fig. A
Fig. B Fig. C

Publicidad

Tabla de contenido
loading

Tabla de contenido