Husqvarna Aspire P5-P4A Manual De Usuario página 22

To stop the product Aspire PE5-P4A
1. Release the power trigger.
2. Push the lock button for the power trigger lockout
rearward to lock the product.
Introduction
WARNING:
safety chapter before you do maintenance
work on the product.
Maintenance schedule
Maintenance
Clean the external parts of the product with a
dry cloth. Do not use water.
Make sure that the start and stop button op-
erate correctly and are not damaged.
Make sure that the power trigger and the
power trigger lockout operate correctly from
a safety point of view.
Make sure that all controls operate correctly
and are not damaged.
Keep the handles dry and clean. Makes sure
that that there is no oil and grease on the
handles.
Make sure that the saw chain cover is not
damaged. Replace the saw chain cover if it is
damaged.
Make sure that the screws and nuts are tight.
Make sure that the battery release buttons
on the battery operate correctly and lock the
battery in the product.
Make sure that the battery charger operates
correctly.
Make sure that the battery is not damaged.
Make sure that the battery is charged.
Make sure that the battery charger is not
damaged.
Do a check of the saw chain.
Sharpen the saw chain.
Do a check of the tension in the saw chain.
Lubricate the saw chain.
22
Maintenance
Read and understand the
Daily
3. Push the battery release button and pull out the
battery. (Fig. 67)
4. If it is necessary, remove the telescopic shaft from
the product.
WARNING:
you do maintenance on the product.
Weekly
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Remove the battery before
Monthly
1867 - 007 - 10.01.2024