Husqvarna Aspire P5-P4A Manual De Usuario página 20

2. Tighten the knob (C).
Note:
When the pruner is attached to the
telescopic shaft, the user interface of the pruner is
disconnected.
To adjust the length of the telescopic
shaft
1. Loosen the screw handle on the shaft (A). (Fig. 49)
2. Adjust the shaft to an applicable length.
3. Tighten the screw handle (B).
To install the hook on the wall
• Install the hook indoors.
• Keep the hook out of sunlight and in ambient
temperature of -10°C to 70°C.
• Install the hook on a drywall, wood or concrete wall.
CAUTION:
can hold loads of minimum 30 kg.
To do a function check before you use
the product
1. Examine the air intake for dirt and damage. Remove
dirt and unwanted material from the product with a
brush.
2. Tighten all nuts and screws.
3. Make sure that the pruner is attached correctly.
4. Examine the pruner for damages, for example,
cracks. Replace pruner if it is damaged.
5. Make sure that the covers are attached correctly and
not damaged.
6. Make sure that the product operates correctly.
Battery
WARNING:
you must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
Keep the battery and the battery charger in correct
ambient temperatures.
Ambient temperature
Operation of the bat- -5 °C – 40 °C
tery in the product
20
Make sure that the wall
Operation
Before you use the battery,
• Install the hook on the wall with the 3 screws (A).
Use wall plugs (B) if it is necessary.
CAUTION:
screws are applicable for your wall type.
a) For Aspire P5-P4A: (Fig. 50)
b) For Aspire PE5-P4A: (Fig. 51)
• Speak to your Husqvarna service agent for
information about available storage accessories for
your product.
To hang the product on the hook
• Hang the pruner on the hook as shown in the
illustration. (Fig. 52)
• Hang the pole on the hook as shown in the
illustration. (Fig. 53)
Ambient temperature
Charging of the bat- 0 °C – 35 °C
tery
To charge the battery
Charge the battery before the first use.
Note:
The charging process is only possible when
the temperature of the battery is within the permitted
charging temperature range (0 °C – 35 °C).
1. Connect the power cord for the battery charger in a
grounded mains.
CAUTION:
mains has the correct voltage and
frequency.
2. Put the battery in the battery charger. The battery
is connected to the battery charger when the green
LED flashes. (Fig. 54)
3. The battery is fully charged when the green LED
on the battery charger is on. Charge the battery for
maximum 24 hours.
4. Disconnect the battery charger from the mains.
CAUTION:
cord.
5. Remove the battery from the battery charger.
Make sure that the
Make sure that the
Do not pull the power
1867 - 007 - 10.01.2024