Setup Instructions - Bestway Hydro-Force SUP 65392 Manual Del Usuario

PARTS & TOOLS NEEDED
Compare the parts in your box to the parts listed on the top of the package. Verify that the equipment components represent the model
that you had intended to purchase.
If any parts are damaged or missing at the time of purchase, visit our website bestwaycorp.com/support.

SETUP INSTRUCTIONS

THIS SUP MUST BE INFLATED BY ADULTS ONLY.
For inflation, follow the drawings inside this manual. Drawings are for illustration purposes only. May not reflect actual product. Not to scale.
: Inflate with built in pump.
A: Inflate with the air compressor. Be sure you use the special connector included in the set (part K).
B: Inflate with a hand pump (not included). We suggest buying a Bestway
pressure gauge that only shows the air pressure when it is above 5 PSI, which is normal. When the air pressure in the product is lower than
5 PSI, the air pressure gauge will not show a value.
IMPORTANT: Never exceed the pressure indicated in the product description table, or it will damage the product, even causing serious
injuries to the user and voiding your warranty.
Built-in Pump Overview
POWER SUPPLY PORT
Use the electric cable (part M) to plug the pump into your car. ONLY use a
car plug.
Close the cap after inflation, every time.
NOTE: To avoid draining the car battery or any cable problems, disconnect
the cable from the power supply port and the car when the pump is not
in use.
INFLATION PORT
Open the cap, switch to activate the built-in pump, and press to start inflation.
Generally, inflation takes approximately 15 minutes, but it also depends on
the condition of the car battery. It will automatically stop when the SUP
reaches the maximum air pressure. You can also pause inflation by simply
pressing the button.
NOTE: The inflation port cannot be used for manual inflation of the SUP.
DEFLATION PORT
This port is designated with two functions - manual inflation and deflation.
For manual inflation, open the cap and press to place the center pin in the
high position. For deflation, open the cap and press the center pin into the
low position.
IMPORTANT: Be careful not to let any water into the pump, which will
damage the electrical parts. Close the caps when the three ports are
not in use, even when the SUP is deflated or in storage.
MAINTENANCE AND STORAGE OF THE SUP
• Extended exposure to sun can shorten the lifespan of your SUP. We suggest not leaving SUPs in direct sunlight for more than 1 hour after use.
• Deflate completely before folding the SUP.
• Store in a cool, dry place and out of children's reach.
• Do not unfold this product when the temperature is low. The product should be placed at room temperature (over 20 ˚C/ 68 ˚F) for 24 hours
before inflation.
IMPORTANT: Be careful not to let any water into the pump, which will damage the electrical parts. Close the caps when the three ports
are not in use, even when the SUP is deflated or in storage.
high pressure hand pump. Bestway pumps are equipped with a
®
Inflation Port
3
Power Supply Port
Deflation Port