Publicidad
Idiomas disponibles
Idiomas disponibles
The display shows the following screen page:
Press the
.key.to.confirm.reset.to.factory.data.
Press the key
3.15 FIRMWARE UPDATE
The.following.function.allows.you.to.update.the.video.door.phone.firmware.using.an.SD.card..The.update.
file.must.be.loaded.onto.the.SD.memory.card.
ATTENTION! It is advisable to carry out the update procedure via the SD card on the video door phones
configured.in Local power.use.mode..If.the.video.door.phone.is.configured.in.another.mode,.make.sure.
that the other video door phones in the riser column are not used until the end of the update procedure and
no calls are made from the calling station.
The firmware update can also be performed using the CallMe Set app (refer to the
mode
chapter).
To.update.the.firmware,.follow.the.procedure.below:
1. Click on the following link to download the
2.. Once.the.download.is.complete,.unzip.the.downloaded..zip.file.
3.. By.unpacking.the.file,.a.new .zip file will appear with the following wording:
1760.16_vx.y.z-w_fup.zip
(*) vx.y.z-w is the FW version of the video door phone.
ATTENTION! Do not unzip the file 1760.16_vx.y.z-w_fup.zip
4.. Load.the.update.file.onto.the.SD.card.
5. Insert the SD card into the appropriate slot on the right side of the video door phone.
6. Use a pointed tool to press the restart button in the hole located on the lower right side of the video door
phone.
DS1760-041B
to cancel and return to the previous page.
Update file
of the video door phone.
Maintenance
33
Publicidad
