instructions.
• Appliance, s manufactures storage recommendations should be strictly adhered
to. Refer to relevant instructions.
• Do not place carbonated of fizzy drinks in the freezer compartment as it creates
pressure on the container, which may cause it to explode, resulting in damage to
the appliance.
• Ice lollies can cause frost burns if consumed straight from the appliance.
• To avoid contamination of food, please respect the following instructions.
• Opening the door for long periods can cause a significant increase of the
temperature in the compartments of the appliance.
• Clean regularly surfaces that can come in contact with food and accessible
drainage systems.
• Store raw meat and fish in suitable containers in the refrigerator, so that it is not in
contact with or drip onto other food.
• Two-star frozen-food compartments (if they are presented in the appliance) are
suitable for storing pre-frozen food, storing or making ice-cream and making ice
cubes.
• One, two and three -star compartments (if they are presented in the appliance) are
not suitable for the freezing of fresh food.
• lf the appliance is left empty for long periods, switch off, defrost, clean, dry and
leave the door open to prevent mount developing within the appliance.
CARE AND CLEANING
• Before maintenance, switch off the appliance and disconnect the mains plug from
the mains socket.
• Do not clean the appliance with metal objects.
• Do not use sharp objects to remove frost from the appliance. Use a plastic scraper.
• Regularly examine the drain in the refrigerator for defrosted water. lf necessary,
clean the drain. lf the drain is blocked; water will collect in the bottom of the
appliance.
INSTALLATION
• Important! For electrical connection carefully follow the instructions given in
specific paragraphs.
• Unpack the appliance and check if there are damages on it. Do not connect the
appliance if it is damaged. Report possible damages immediately to the place you
bought it. ln that case retain packing.
• lt is advisable to wait at least four hours before connecting the appliance to allow
the oil to flow back in the compressor.
• Adequate air circulation should be around the appliance, lacking this leads to
overheating. To achieve sufficient ventilation, follow the instructions relevant to
installation.
• Wherever possible the spacers of the product should be against a wall to avoid
touching or catching warm parts (compressor, con-denser) to prevent possible
44