Jocel JC326PV Manual De Instrucciones página 56

CLEANING AND CARE
For hygienic reasons the appliance (including exterior and interior accessories) should be cleaned
regularly at least every two months.
Caution! The appliance must not be connected to the mains during cleaning. Danger of electrical
shock! Before cleaning, switch the appliance off and remove the plug from the mains socket.
EXTERIOR CLEANING
To maintain good appearance of your appliance, you should clean it regularly.
• Wipe the digital panel and display panel with a clean, soft cloth.
• Spray water onto the cleaning cloth instead of spraying directly on the surface of the appliance.
This helps ensure an even distribution of moisture to the surface.
• Clean the doors, handles and cabinet surfaces with a mild detergent and then wiped dry with a
soft cloth.
Caution!
• Don't use sharp objects as they are likely to scratch the surface.
• Don't use Thinner, Car detergent, Clorox, ethereal oil, abrasive cleansers or organic solvent such
as Benzene for cleaning. They may damage the surface of the appliance and may cause fire.
INTERIOR CLEANING
You should clean the appliance interior regularly. It will be easier to clean when food stocks are low.
Wipe the inside of the fridge freezer with a weak solution of bicarbonate of soda, and then rinse with
warm water using a wrung-out sponge or cloth. Wipe completely dry before replacing the shelves
and baskets. Thoroughly dry all surfaces and removable parts.
Although this appliance automatically defrosts, a layer of frost may occur on the freezer
compartment's interior walls if the freezer door is opened frequently or kept open too long. If the
frost is too thick, choose a time when the supply of food stocks is low and proceed as follows:
1. Remove existing food and accessories baskets, unplug the appliance from the mains power and
leave the doors open. Ventilate the room thoroughly to accelerate the thawing process.
2. When defrosting is completed, clean your freezer as described above.
Caution!
Don't use sharp objects to remove frost from the freezer. Only after the interior completely dry should
the appliance be switched back on and plugged back into the mains socket.
DOOR SEALS CLEANING
Take care to keep door seals clean. Sticky food and drinks can cause seals to stick to the cabinet
and tear when you open the door. Wash seal with a mild detergent and warm water. Rinse and dry
it thoroughly after cleaning.
Caution! Only after the door seals are completely dry should the appliance be powered on.
REPLACING THE LED LIGHT
Warning: The LED light must not be replaced by the user! If the LED light is damaged, contact the
customer helpline for assistance. To replace the LED light, the below steps can be followed:
1. Unplug your appliance.
2. Remove light cover by pushing up and out.
3. Hold the LED cover with one hand and pull it with the other hand while pressing the connector
latch.
4. Replace LED light and snap it correctly in place.
56