Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Suction nozzle (with brush)
2. Spray nozzle
3. Suction nozzle hanger
4. Spray trigger
5. Lock system
6. Power button
7. Flexible hose
8. Waste-water tank
9. Clean-water tank
10. Slot for suction nozzle hanger
11. Waste water tank cover
12. Clean water tank cover
13. Handle
14. Clean-water tank
15. Lock device
16. Power cable storage
17. Suction/spray head hook
18. Suction filter
19. Flexible hose
NOTE:
the graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
-
Make sure to place the head before using the appliance. Do not try to place or remove the
head during use.
-
It is recommended to clean the appliance before first use with clean water to remove any
dust or residues from the manufacturing process. To do so, carry out the following steps:
-
Slide the suction/spray head hanger into the slots on both sides of the unit.
-
Lift the cover of the clean water tank, pour in up to 1.4 L of tap water and then lower the
cover.
-
Make sure the filter is placed in the waste water tank.
WARNING: only use tap water or ionised alkaline water. Empty the water tank after each use.
Storing water in the tank for long periods can lead to mould or leaks.
48
CONGA 5000 CARPET&SPOT CLEAN
Publicidad
