Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Note:
The water that is sprayed is absorbed quickly, so it is advisable not to spray too much water
continuously on the same surface. If there is excess water, it can permeate excessively into
the surface, making it difficult for the vacuum cleaner to absorb it, and mould may develop.
Water suction
-
Once water has been sprayed on the surface to be cleaned, press the suction nozzle firmly
onto the surface.
-
Move the suction head towards your while keeping pressure on the surface as you suck up
the water. The suctioned water will enter the waste water tank.
Note:
If the water in the waste water tank reaches its capacity limit (1.2 L), please stop using the
appliance, unplug it and lift the waste water tank to remove it. Empty it and make sure to install
it correctly before switching on the appliance again. Never remove the tank while the appliance
is in use.
After use
1. Once all the water has been removed from the surface to be cleaned, press the power
button to switch off the appliance. After that, unplug it.
Note:
Make sure your hands are dry before pressing the power button or touching the cord and plug.
2. Lift the waste water tank. Empty and rinse it before reassembly. It is advisable to place it
under a tap so that it can be cleaned in the best possible way.
3. Empty the clean water tank if it still has water.
Note:
If the main body accidentally gets wet, remove the suction/spray head, the flexible hose and
the waste water tank, and let the appliance run for 5 to 10 minutes to allow the internal part
to dry.
Use of detergents
-
In the case of an ingrained stain, detergent can be applied first to help dissolve the mark.
Note:
Do not put detergent in the clean water tank. Only apply it to the stained area.
-
When using detergent, test a small area of the upholstery to check that it does not
discolour or cause other problems.
50
CONGA 5000 CARPET&SPOT CLEAN
Publicidad
