cecotec CONGA 5000 CARPET&SPOT CLEAN Manual De Instrucciones página 51

Note:
Do not use thinners, volatile oils, chlorinated bleach, flammable solvents, or solvents. They can
cause discolouration, malfunction and fire. In addition, the use of neutral kitchen detergent,
strong alkaline detergent, strong acid detergent or very foamy detergents is not recommended
(as they may cause the foam to soak into the cleaner).
It is recommended that you choose the detergent according to the fabric or material to be
treated. Ionised water, sodium carbonate, citric acid, water with hypochlorous acid or mild,
low-foaming detergents are recommended.
1. Apply the detergent to the carpet or upholstery and use the brush head to rub gently into
the fabric. The brush will help to open up the weave of the fabric so that the detergent
can penetrate more effectively and remove the stain. Do it carefully, as some fabrics are
extremely delicate.
2. Press the spay trigger to wet the area. You can gently brush the area again once it is wet.
3. Once the area is sufficiently wet, vacuum the water with the suction head.
4. Spray more water over the area to ensure that all stains and detergent are removed.
Vacuum the water again. Repeat the process if necessary.
Note:
Stop operation when the foam in the water in the waste water tank reaches the MAX line. Do
not exceed this line, otherwise the foam could get into the main motor and cause damage to
the appliance. If this happens, switch off the device and clean it.
4. CLEANING AND MAINTENANCE
- Empty the water from the tanks as explained in the section "After use".
- Wipe the main body with a clean, soft cloth dampened with water.
- If there are any stubborn stains, apply a small amount of detergent to the cloth and wipe
the area. After cleaning, make sure to rinse the area thoroughly until no detergent residue
remains.
- Remove the suction/spray head and the flexible hose.
- Lift and remove the waste water tank.
CONGA 5000 CARPET&SPOT CLEAN
ENGLISH
51