Whirlpool W11I OP1 4S2 H Manual Del Usuario página 5

2. Create an account
If you haven't done so already, you'll need to Create an
account. This will enable you to network your appliances
and also view and control them remotely.
3. Register your appliance
Follow the instructions in the app to register your appliance.
You will need the Smart Appliance IDentifier (SAID) number
to complete the registration process. You can find its unique
code the number on the identification plate attached to the
product.
4. Connect to WiFi
Follow the scan-to-connect setup procedure. The app
will guide you through the process of connecting your
appliance to the wireless network in your home.
If your router supports WPS 2.0 (or higher), select
"MANUALLY", then tap "WPS Setup": Press the WPS button
on your wireless router to establish a connection between
the two products.
If necessary, you can also connect the product manually
using "Search for a network".
The SAID code is used to synchronise a smart device with your
appliance.
The MAC address is displayed for the WiFi module.
The connection procedure will only need to be carried out
again if you change your router settings (e.g. network name
or password or data provider).
3. SETTING THE TIME AND DATE
Connecting the oven to your home network will set the
time and date automatically. Otherwise you will need to set
them manually
• Tap the relevant numbers to set the time.
• Tap "SET" to confirm.
Once you have set the time, you will need to set the date
• Tap the relevant numbers to set the date.
• Tap "SET" to confirm.
After a long power loss, you need to set the time and date
again.
4. SET THE POWER CONSUMPTION
The oven is programmed to consume a level of electrical
power that is compatible with a domestic network that has a
rating of more than 3 kW (16 Ampere): If your household uses a
lower power, you will need to decrease this value (13 Ampere).
• Tap the value on the right to select the power.
• Tap "OKAY" to complete initial setup.
5. HEAT THE OVEN
A new oven may release odours that have been left behind
during manufacturing: this is completely normal. Before
starting to cook food, we therefore recommend heating the
oven with it empty in order to remove any possible odours.
Remove any protective cardboard or transparent film from
the oven and remove any accessories from inside it. Heat
the oven to 200 °C for around one hour.
It is advisable to air the room after using the appliance for the first
time.
6. FILL THE RESERVOIR
To allow the emission of steam during cooking, this device is
equipped with a reservoir (not visible).
Selecting a recipe or a cycle that requires steaming, the display
will ask you to insert the inlet pipe for loading water and a led
close to the insertion area will turn on.
Connect the pipe without pressing the button. Once the pipe
is completely inserted, you will hear a click.
Please note: There is only one way to connect the pipe correctly,
keeping the push button on the left side.
Then place the end of the pipe in a jug/container filled with at
least 1,7 liters of drinking water. For an optimal steam
performance it is recommended to load the reservoir with
ambient temperature water. If you place the container on the
appliance door, please take care to place it gently in order to
avoid any damage to the door glass.
close the door.
Now it is possible to start the cooking cycle or the desired
recipe.
After a long period of non-use of the Steam functions, it is highly
suggested to activate a steam cooking cycle with the empty oven
by filling completely the reservoir.
Once started, the process will
stop automatically when the
reservoir is filled.
At the end, the display will
prompt to unplug the pipe
pressing the button on its upper
left side and lightly pulling down.
Please note: In order to avoid any
water leakage, it is recommended
to disconnect the filling accessory
while it is still inside the drain
container; then remove them and
EN
5